TruScan Photobeam Activity System
E63-01HS TruScan Linc
One Linc is required for each Arena. The system can control up to 10 Lincs and 10 Arenas, with 3 Sensor Rings each.
Each Linc has a microprocessor on board to control scanning, calculate the coordinate sets for each of the rings and report to the host computer. The Linc has LEDs to show the status of the experiment and a control switch that provides a way to start stations or resume recording after a pause when the environmental test equipment is in a separate room from the computer.
The Sensor Rings plug into the back of the Linc. The specific connector into which a ring is plugged determines its function: floor, nose poke, or rearing. There are also four stimulus output jacks on the back of the Linc; one is controlled by a timer and set on the front panel. Any stimulus device may be connected to one of the outputs and controlled by the Tru Scan software.
Dimensions: 3.25 in H, 10 in W, 7 in
Power: 9 VDC (wall mount supply)
Connectors: 3 Sensor Rings, 1 LabLinc Cable, 1 9-VDC Power Inlet, 4 Stimulus
control lines, 5VTTL
PCI-3-KIT : PCI Computer Interface Card (picture)
L18-16XHS-10A : Expander Box (for 2-10 stations) (picture)